UTILIZATION OF ZEOLITS FOR WATER FILING

Authors

  • Sajaratud Dur Universitas Islam Negeri Sumatera Utara Medan

DOI:

https://doi.org/10.30829/zero.v2i1.3182

Abstract

This study aims to obtain zeolite powder from Sarulla natural zeolite as an adsorbent, particle size of zeolite powder, and water analysis before and after water purification. The benefit is to increase the benefits of zeolite to a higher economic value.The method used is the grinding mill method to smooth the zeolite chunks. Whereas the water purification process uses a screening process.The results of this study were zeolite produced at 200 mesh or 74 microns, and the purification was successfully carried out.The conclusion of this study is that zeolite powder obtained from Sarulla natural zeolite as an adsorbent, obtained zeolite particles namely 200 mesh or 74 microns, and the water purification process was successfully carried out.

References

Aini, M.N., dan Indriati, L., (2007), "Proses Pemutihan Zeolit sebagai Bahan Pengisi Kertas", Buletin, Balai Besar Pulp dan Kertas, Bandung.

Coed, M.A, (1991), "Kimia Polimer", Bandung: Institut Teknologi Bandung.

Fengel, D., dan Wegener, G., (1995), "Kayu: Kimia, Ultrastruktur, Reaksi - Reaksi", Buku Teks, Gajah Mada University Press, Yogyakarta.

Hanafi, I., Halimatuddahliana, dan Hazizan, (2005), "Properties of Polypropylene/Ethylene-Propylene Diene Terpolymer/Natural Rubber (Pp/Epdm/Nr) Ternary Blend: The Effect of Dynamic Vulcanization", Solid State Science and Technology, Vol.13, No.1 & 2.

Harahap, S, (2006), "Kajian Bahan Laporan Akhir, Badan Penelitian dan Pengembangan Propinsi Sumatera Utara, Medan.

Ismail, H, and Suryadiansyah, R, (2004), "Effects of Filler on Properties of

Kohls, J. J., and Beaucage, (2002), "Rational Desing of Reinforced Rubber", Cur OP. Solid St Mat Sci., 6:183-194.

Mc.Bain, J.W, (1932), "The Sorption of Gases and Vapors by Solids", Chapter 5, Rutledge and Sons, London.

Mozgawa, W, Krol, M, and Barczyk, K, (2011), " FT-IR Studies of Zeolites from Different Structural Groups, Faculty of Materials Science and Ceramics, AGH University of Science and Technology, Kraków, Please cite as: CHEMIK, 65, 7, 667-674

Samir, M. A. S. A., F. Alloin, J. Sanchez and A. Dufresne. (2004), "Cross-Linked Nanocomposite Polymer ElectrolytesReinforced With Cellulose Whiskers", Macromolecules. 37:4839-4844.

Yu, L, (2009), "Biodegradable Polymer Blends and Composites from Renewable Resources", Canada: John wiley and Sons.

Zhai,L.L, Ling, G.P, and Wang, Y.W, (2007), "Effect of nano-Al2O3 on adhesion strength of epoxy adhesive and Steel", College of Materials Science and Chemical Engineering, Zhejiang University, Hangzhou 310027, People's Republic of China, International Journal of Adhesion & Adhesives 28: 23-28.

Downloads

Published

2019-01-04

Issue

Vol. 2 No. 1 (2018): January - June

Section

Articles

License

Authors who publish with this journal agree to the following terms:

  1. Authors retain copyright and grant the journal right of first publication with the work simultaneously licensed under a Creative Commons Attribution-ShareAlike 4.0 International License that allows others to share the work with an acknowledgement of the work's authorship and initial publication in this journal.
  2. Authors are able to enter into separate, additional contractual arrangements for the non-exclusive distribution of the journal's published version of the work (e.g., post it to an institutional repository or publish it in a book), with an acknowledgement of its initial publication in this journal.
  3. Authors are permitted and encouraged to post their work online (e.g., in institutional repositories or on their website) prior to and during the submission process, as it can lead to productive exchanges, as well as earlier and greater citation of published work (See The Effect of Open Access).